P0007 fault code: Fuel Shutoff Valve 'A' Control Circuit High
We have no verified driving guidance for P0007. Treat as do not drive until checked. Do not unplug a high-circuit shut-off valve while the pump is primed.
Can I DIY?
Professional-only boundary. Do not swap shut-off valve A to chase a high-circuit reading.
This is the conservative boundary from the reviewed code record. This page has no frozen site-wide safety grade, so it does not publish a repair route.
What to tell the garage about P0007
Do not drive until checked. Fuel shut-off valve A’s control circuit is sitting high. The computer sees too much voltage on that command wire — the opposite electrical condition to P0006.
Take these reviewed, code-specific details with you. They help the garage confirm the fault without turning this page into a repair procedure.
- Fuel Shutoff Valve 'A' Control Circuit High: Registration number
- Fuel Shutoff Valve 'A' Control Circuit High: Exact code P0007 and any companion codes from the same scan
- Fuel Shutoff Valve 'A' Control Circuit High: Whether the engine management light is steady or flashing
- Fuel Shutoff Valve 'A' Control Circuit High: Whether the engine ran on after the ignition was switched off
What does P0007 mean?
P0007 is a generic (SAE standard) powertrain code reported by your car’s engine control unit. It sits in the P00xx block, which covers fuel and air metering. The stored description is “Fuel Shutoff Valve 'A' Control Circuit High”. The code itself tells you which circuit or system tripped the fault — not always the exact part that failed.
Will P0007 fail an MOT?
An illuminated engine management light is a Major MOT fail until the lamp stays off. P0007 flags a high control circuit on shut-off valve A, not a turbo or oxygen-sensor heater fault.
Before booking your test, check what usually fails on your car: see our MOT pass rates by make and model, built from 33.1 million DVSA tests.
Related guides
Related fault codes
P0007 — quick answers
Is it safe to drive with P0007?
Do not drive until checked. We have no verified driving guidance for P0007. Treat as do not drive until checked. Do not unplug a high-circuit shut-off valve while the pump is primed.
Will P0007 fail my MOT?
An illuminated engine management light is a Major MOT fail until the lamp stays off. P0007 flags a high control circuit on shut-off valve A, not a turbo or oxygen-sensor heater fault.
Fault-code identifiers are standard diagnostic facts. Their explanations and diagnostic guidance on this site are original editorial summaries, not reproduced SAE wording. MOT defect rules reflect the DVSA MOT inspection manual (2026). This page is general guidance for UK drivers, not a substitute for a professional diagnosis.